SICK Inspector PIM60 series

CommentBinaryRangeAttributeValue tagContainer tag
0=not found, 1=found, 2=Out-
side image
USINT{0, 1, 2}DECISION
Name attribute required if
more than one Bead exists.
any stringnameBEAD
Minimum width of bead.REALcoordUnitMIN_WIDTH
Maximum width of bead.REALcoordUnitMAX_WIDTH
Mean width of bead.REALcoordUnitMEAN_WIDTH
Number of consecutive probes
where the width was too nar-
row.
UINT[0, 256]NUM_TOO_
NARROW
Number of consecutive probes
where the width was too wide.
UINT[0, 256]NUM_TOO_
WIDE
Total number of probes where
the width was too narrow.
UINT[0, 256]TOTAL_NUM_
TOO_NAR-
ROW
Total number of probes where
the width was too wide.
UINT[0, 256]TOTAL_NUM_
TOO_WIDE
1=pass, 2...62=logical OR of
the five tolerances: 2=Mean
USINT[{1,2,4,6,
8,...,54,56,
DECISION
width fail, 4=Longest sequence
58,60,62}]
of too narrow probes fail,
8=Longest sequence of too
wide probes fail, 16=Total
amount of too narrow probes
fail, 32=Total amount of too
wide probes fail.
Name attribute required if
more than one Polygon exists.
any stringnamePOLYGON
Number of corners used for
this polygon tool.
USINT[2, 16]NUM_
CORNERS
0=not found, 1=defect, 2 =
pass
USINT{0, 1, 2}DECISION
Polygon matching score.REAL[0, 100]SCORE
Number of defect pixels inside
crack detection region in poly-
UDINTNUM_
PIXELS
gon. Undefined for single edge
tool.
0=polygon completely inside
image, 1=one or more polygon
USINT{0,1}CORNER_
OUTSIDE
corner(s) are outside image.
Cannot be used for single edge
tool.
Coordinate of the first found
pixel that was within the defect
REALcoordUnitDEFECT_X
thresholds. In “pixels” or “mm”
depending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
8015726/ZPP7/2018-
09
©SICK AG • Identification & Measuring • www.sick.com • All rights reserved
Subject to change without notice
42
Reference Manual
Result output formatting
Appendix
Inspector PIM