SICK Inspector PIM60 series - Page 43

CommentBinaryRangeAttributeValue tagContainer tag
Return -1 if defect detection is
not active or no defect found.
Undefined for single edge tool.
Coordinate of the first found
pixel that was within the defect
REALcoordUnitDEFECT_Y
thresholds. In “pixels” or “mm”
depending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Return -1 if defect detection is
not actived or no defect found.
Undefined for single edge tool.
"All"
b
iterates over all polygon
corners. Number 0 to 15 gives
{0, 1,
...,15, all}
cornersCORNERS
a
the properties of a single
corner. The index of this corner
is the order in which the poly-
gon corner was added when
the polygon was drawn.
Polygon corner coordinate. In
“pixels” or “mm” depending on
REAL
c
REALcoordUnitX
attribute “coordUnit” or con-
figured value in the Ethernet
Result output dialog.
For a polygon with two corners
(single edge) the estimated
corner positions are the inter-
section between the found
edge and the left and right
borders of the search region.
The search region is defined by
the user drawn edge and the
position search parameter. See
also Operating Instructions for
Inspector PIM60 about Single
edge tool.
Polygon corner coordinate.
“pixels” or “mm” depending on
REAL
c
REALcoordUnitY
attribute “coordUnit” or con-
figured value in the Ethernet
Result output dialog.
For a polygon with two corners
(single edge) the estimated
corner positions are the inter-
section between the found
edge and the left and right
borders of the search region.
The search region is defined by
the user drawn edge and the
position search parameter. See
also Operating Instructions for
Inspector PIM60 about Single
edge tool.
43
©SICK AG • Identification & Measuring • www.sick.com • All rights reserved
Subject to change without notice
8015726/ZPP7/2018-
09
Appendix
Result output formatting
Reference Manual
Inspector PIM