SICK Inspector PIM60 series - Page 45

CommentBinaryRangeAttributeValue tagContainer tag
Edge matching score.REAL[0, 100]SCORE
In degrees or radians depend-
ing on attribute “unit” or con-
REAL[0, 180]unitANGLE
figured value in the Ethernet
Result output dialog.
0=not found, 1=found, 2=Out-
side image
USINT{0, 1, 2}DECISION
Name attribute required if
more than one Circle exist
any stringnameCIRCLE_LOCAT-
OR
X position of the reference
point. In “pixels” or “mm” de-
REALcoordUnitX
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Y position of the reference
point. In “pixels” or “mm” de-
REALcoordUnitY
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Circle matching score.REAL[0, 100]SCORE
Circle's diameter in pixels or
mm depending on attribute
REALcoordUnitDIAMETER
"coordUnit" or configured value
in the Ethernet Result output dia-
log.
0=not found, 1=pass, 2=Out-
side image, 11=Failed on score
value, 12=Failed on diameter
USINT{0, 1, 2,
11, 12}
DECISION
Name attribute required if
more than one Measure dis-
tance exists
any stringnameMEASURE_DIS-
TANCE
Measured distance in pixels or
mm depending on attribute
REALcoordUnitDISTANCE
“coordUnit” or configured value
in the Ethernet Result output dia-
log.
Indicates whether the value in
the distance tag is a valid
USINT{0, 1}VALID
measurement or not. 0=Invalid
1=Valid
0=fail (measure distance could
not be done), 1=pass
USINT{0, 1}DECISION
Name attribute required if
more than one Measure Angle
exist
any stringnameMEAS-
URE_ANGLE
X position of the intersection
point. In “pixels” or “mm” de-
REALcoordUnitX
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
45
©SICK AG • Identification & Measuring • www.sick.com • All rights reserved
Subject to change without notice
8015726/ZPP7/2018-
09
Appendix
Result output formatting
Reference Manual
Inspector PIM