CommentBinaryRangeAttributeValue tagContainer tag
Y position of the intersection
point. In “pixels” or “mm” de-
REALcoordUnitY
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
In degrees or radians depend-
ing on attribute “unit” or con-
REAL[0, 180]ANGLE
figured value in the Ethernet
Result output dialog.
Indicates whether the values
in the angle tag are valid
USINT{0, 1, 2}VALID
measurements or not. 0=Inval-
id 1=Valid 2=Intersection out-
side image
0=fail, 1=passUSINT{0, 1}DECISION
Name attribute required if
more than one Edge counter
exist
any stringnameEDGE_COUNT
Chosen feature/edge index.[0, 63]index
Number of found features.USINT[0, 64]FOUND_FEA-
TURES
e
If the chosen Edge counter is
rectangular the value shows
REALco-
ordUnit/unit
MIN_PITCH
e
the pitch “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
If the chosen Edge counter is
circular the value is the pitch
in degrees or radians depend-
ing on attribute “unit” or con-
figured value in the Ethernet
Result output dialog.
If the chosen Edge counter is
rectangular the value shows
REALco-
ordUnit/unit
MAX_PITCH
e
the pitch “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
If the chosen Edge counter is
circular the value is the pitch
in degrees or radians depend-
ing on attribute “unit” or con-
figured value in the Ethernet
Result output dialog.
If the chosen Edge counter is
rectangular the value shows
REALco-
ordUnit/unit
MEAN_PITCH
e
the pitch “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
8015726/ZPP7/2018-
09
©SICK AG • Identification & Measuring • www.sick.com • All rights reserved
Subject to change without notice
46
Reference Manual
Result output formatting
Appendix
Inspector PIM
To Next Page
Loading...
