SICK Inspector PIM60 series

CommentBinaryRangeAttributeValue tagContainer tag
If the chosen Edge counter is
circular the value is the pitch
in degrees or radians depend-
ing on attribute “unit” or con-
figured value in the Ethernet
Result output dialog.
0=Not found, 1=Found,
2=Outside image
USINT{0, 1, 2}DECISION
e
X position for the mid point of
the feature/edge, see foot-
REALcoordUnitX
note
f
. In “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Y position for the mid point of
the feature/edge, see foot-
REALcoordUnitY
note
f
. In “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
Only applicable for Feature type
Single edge. A positive value is
REAL[0, 180]ANGLE
a clockwise rotation and a
negative value is a counter
clockwise rotation.
g
The angle of the single edge in
degrees or radians depending
on attribute “unit” or con-
figured value in the Ethernet
Result output dialog.
Only applicable for Feature type
Dark or Bright. The edge's or
REAL[0, 180]INTERN-
AL_ANGLE
feature's angle in the search
region.
h
The angle of the feature in de-
grees or radians depending on
attribute “unit” or configured
value in the Ethernet Result out-
put dialog.
Only applicable for Feature type
Dark or Bright.
REALWIDTH
If the chosen Edge counter is
rectangular the value shows
the width “pixels” or “mm” de-
pending on attribute “co-
ordUnit” or configured value in
the Ethernet Result output dialog.
If the chosen Edge counter is
circular the value is the width
in degrees or radians depend-
ing on attribute “unit” or con-
47
©SICK AG • Identification & Measuring • www.sick.com • All rights reserved
Subject to change without notice
8015726/ZPP7/2018-
09
Appendix
Result output formatting
Reference Manual
Inspector PIM