SICK ISD400 Pro - 8.4 Changing Device Values

8016441/2013-11-22•©SICKAG•Subjecttochangewithoutnotice 33
Operating the device
8.4 Changing the value
1. Selectthedesiredparameterusingthe , ,and pushbuttons.
2. Pressthe
pushbutton.Thecurrentvalueoftheparameterisdis-
played.Therstdigitontheleftashes.
3. Pressthe
pushbuttontoincreasethedigit.Pressthe pushbut-
tontolowerthedigit.
4. Pressthe
pushbuttontosavethedigitentered.Thenextdigit
ashes.
Pressthe pushbuttontocanceltheprocess.
5. Repeatsteps3and4untilthelastdigitissaved.Theparametername
isdisplayed.
6. Pressthe
pushbuttonrepeatedlyuntilthereceivedsignallevelis
displayedoncemore.Alternatively,youcanwaitafewminutes.The
displaywillautomaticallyswitchbacktothereceivelevelindicatorifno
buttonsarepressed.