Ethernet connections
Figure 6: Ethernet connections
P
ort 1: 100 MBit/s
Port 2: 1 GBit/s
Port 3: 100 MBit/s
Port 4: 1 GBit/s
5.3.3.3 Connecting peripheral devices
The device can be connected to a wide range of sensors and cameras.
T
he required pin assignments can be found in the data sheets for the peripherals to be
connected as well as in the relevant connection descriptions.
•
Connect the cables to peripheral devices.
•
Route the cables to the device using installation materials (cable channels, cable
ties, etc.). When doing so, pay attention to cable strain relief.
•
Connect cables to the relevant device connections and screw together tightly.
Further topics
•
"P
in allocations of the connections", page 12
5 ELE
CTRICAL INSTALLATION
14
T E C H N I C A L I N F O R M A T I O N | LiDAR Localization Hardware Integration 8024819/2019-09-02 | SICK
Subject to change without notice
To Next Page
Loading...
Need help?
General
