2 Safety information
2.1 General safety notes
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
Machinery Directive.
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
Laser notes
CAUTION
Interference, manipulation or incorrect use can lead to hazardous exposure due to laser
radiation.
The emitted light beam must not be focused by means of additional optical devices.
Figure 1: Laser class 1
This device complies with the following standards:
•
EN/IEC 60825-1:2014
•
21 CFR 1040.10 and 1040.11 except for tolerances according to Laser Notice No.
56 dated May 8, 2019.
This laser product corresponds to laser class 1 after having been assessed on the
basis of the Low Voltage Directive 2014/35/EU, which applies to all manufacturers
placing products on the market, in conjunction with EN/IEC 60825-1:2014 in the
currently applicable version. Due to the differing statutory requirements on occupa‐
tional safety according to guideline 2006/25/EC, this product has to be assessed
based on the older standard EN60825-1:2007. According to the older standard
EN60825-1:2007, this product is partially classified in laser class 2 and is considered
safe when used as intended.
The laser is eye-safe.
The laser marking is located on the housing imprint on the sensor.
2.2
Intended use
The WTF12L/WTF12V is particularly suited to the detection of flat, glossy, contrast-rich,
and uneven objects.
OPERATING INSTRUCTIONS
28
O P E R A T I N G I N S T R U C T I O N S | WTF12L/WTF12V 8027710/2022-04-12 | SICK
Subject to change without notice
en
To Next Page
Loading...
