UM353-1B Data Mapping
April 2012
6-3
RTS R/W Front Port (Display Assembly) RTS 1-3 ($0001-$0003) 40050
reserved 40051-40057
MLTP R/W Modbus Loop Trend Pointer 0-25 ($0000-$0019) 40058
NLTB R Number of Loop Trend Blocks 0-5 ($0000-$0005) 40059
AASEL R/W Active Ack’d Station Error Log 0-33767($0000-$7FFF) 40060
STY R/W (1) Standard Time in Years 2000-2099 40061
STM R/W (1) Standard Time in Months 1-12 40062
STD R/W (1) Standard Time in Days 1-31 40063
STH R/W (1) Standard Time in Hours 0-23 40064
STMN R/W (1) Standard Time in Minutes 0-59 40065
STSC R/W (1) Standard Time in Seconds 0-59 40066
NAL R No of Analog Ind. Loops (ODA) 0-255($0000-$00FF) 40067
NDL R No of Discrete Ind. Loops (ODD) 0-255($0000-$00FF) 40068
NDP R No of Pushbutton Loops (ODP) 0-255($0000-$00FF) 40069
IPA1 R IP Address (2) 1: 0-255, 2: 0-255 40070
IPA2 R IP Address (2) 3: 0-255, 4: 0-255 40071
IPG1 R IP Gateway Address (4) 1: 0-255, 2 0-255 40072
IPG2 R IP Gateway Address (4) 3: 0-255, 4: 0-255 40073
IPM1 R IP Mask (3) 1: 0-255, 2: 0-255 40074
IPM2 R IP Mask (3) 3: 0-255, 4: 0-255 40075
EBS R Ethernet Board Speed 0-auto, 1-10M, 2-100M 40076
EBD R Ethernet Board Duplex 0-auto, 1-half duplex, 2-full duplex 40077
PPR R Ethernet Board Peer-to-Peer Rate 0.25, 0.5, 1, 2, 5, 10 sec 40078
Spares 40079-40100
Software Revisions:
Development Release MSB 128 to 255 ($80-$FF)
Major Rev. MSB 1 to 127 ($00-$7F) (5)
Minor Rev. LSB 0 to 255 ($00-$FF)
Hardware Type and Revisions:
Type MSB 1 to 15 ($01-$0F) (5)
Rev. LSB 1 to 15 ($01-$0F)
(1) The controller time should be changed one parameter at a time and then verified before writing the next
parameter (i.e. for Modbus use command 06 and not command 16). Write the year only (i.e. for 2006 write
a 6). The change to each parameter will take approximately 1 to 2 seconds each.
(2) IP Address format (nnn.nnn.nnn.nnn) 1,2,3,4 (default 192.168.0.2)
(3) IP Mask format (nnn.nnn.nnn.nnn) 1,2,3,4 (default 255.255.255.0)
(4) IP Gateway format (nnn.nnn.nnn.nnn) 1,2,3,4 (default is 192.168.0.1)
(5) A major software Rev. of 0 = no software included and a hardware type of 0 = not installed.
To Next Page
Loading...
Need help?
General
