22
Using the Meter
With the meter front panel, you can view parameter values; configure
parameters; perform demand resets; perform LED checks; and view meter
information. Each of these functions can be accomplished by pressing the
Up, Down, and Enter buttons on the front panel. These button actions achieve
different results according to the mode that the meter is in:
Display mode (default): view parameter measurements
Reset mode: reset demand measurements
Configuration Select/Edit modes: configure a parameter
Information mode: verify that the front panel display LEDs operate, and
view meter information (e.g. meter options, firmware version, etc.)
This section describes front panel navigation within each mode.
NOTE
You have 60 seconds to move from one screen to another. After 60 seconds,
the front panel defaults to Display mode.
Display Mode
In Display mode, you can view values from these measurement groups:
System (total)
Per Phase, Energy, Demand
Peak Demand
The values you can view depend on which Options package you ordered.
Display Mode Parameter Measurements
1
Displays system (total) values.
x 1000 Indicator
When the “x 1000” LED is lit, multiply the displayed value by 1000 for the
actual value.
Measurement Group
Parameters Measured
(Megawatt meters)
Parameters Measured
(all other models)
System (Total)
kV
AVG,
I
AVG,
MW, MVA, MVAR,
PF, Frequency, I4
V
AVG,
I
AVG,
kW, kVA, kVAR, PF,
Frequency, I4
Phase A, B, and C
kV
LN, k
V
LL,
I, PF, MW, MVA,
MVAR, kV
THD
, I
THD
V
LN,
V
LL,
I, PF, kW, kVA, kVAR,
V
THD
, I
THD
Energy MWh, MVAh, MVARh kWh, kVAh, kVARh
Demand
1
MVA, MVAR, MW, I
AVG
kVA, kVAR, kW, I
AVG
Peak Demand (Max)
1
MVA, MVAR, MW, I
AVG
kVA, kVAR, kW, I
AVG
Min/Max
Min/Max measurements
provided in a future release
Min/Max measurements
provided in a future release
To Next Page
Loading...
