Siemens ARCADIS Avantic - Specific System Settings; System Configuration and Service Login

28 Specific System Settings
ARCADIS Avantic SPR2-330.815.01.03.02 Siemens AG
12.06 CS PS SP
Page 28 of 66
Medical Solutions
3- 3Specific System Settings
System configuration 0
Note regarding Hibernation Mode 0
NOTE
Hibernation Mode
With the introduction of the Hibernation Mode, system configura-
tion changes are not applied if the system is switched off and
then switched on again using the power buttons on the monitor
cart.
To correctly apply the modified data, perform a system shutdown.
Open the <Options> - <End Session> menu and click the “Shut-
down system” button. Immediately thereafter, press the Power off
button on the monitor cart.
The system shuts down and switches off automatically.
Customer and country-specific configurations 0
• Please clarify in advance with the customer whether the following system configura-
tions are required.
Service login: 0
Fig. 6: Service login
• Select <Options> <Customer service> <Local service>.