Siemens ARCADIS Avantic - Final Work Steps; Printer Setup Procedures

To Next Page

To Previous Page

Siemens AG SPR2-330.815.01.03.02 ARCADIS Avantic

12.06 CS PS SP

Final Work Steps 45

Page 45 of 66

Medical Solutions

4- 4Final Work Step s

Paper printer (optional) 0

NOTE

If a paper printer was ordered with the system, all mechanical

work and programming was performed at the factory.

In the case of paper printers delivered after the system, they have

to be installed and started up in accordance with the Installation

and Setting instructions SPR2-310.814.03...

Codonics printer 1660L 0

Perform the following steps according to the "User Manual" of the printer:

• Transport instructions (see preface).

Note: Unpack the printer and remove the two transport pins. Place the printer in the

cart, connect the power cable and the 25-pin plug to the printer (cables are ready for

use in the printer slot of the cart), and set the power switch to "1".

• Install the print media>(SPR2-310.815.01 / General Start-up)

NOTE

Keep the transport safety materials. They are required when

replacing or shipping the printer.

Sony printer UP-D72 X 0

Perform the following steps according to the user manual for the printer (CD-ROM):

• Unpack the printer.

• Fill the paper tray with paper (follow instructions on paper package).

• Plug in the USB cable.

• Print a test page after the automatic test.

• Follow the instructions on the CD-ROM from the manufacturer in the event of problems.