18/36
Siemens Climatix HMI-DM CB1P3916en02
Building technologies Functions and operations 2015-07-02
4.4 Log in
After the communication between HMI and controller has been set up, users can
log in with one of the following different user levels listed in the table.
Not Login
The access rights of this
level are suitable for users
who view the basic
information of Climatix
controllers.
No password required. The
setting is in accordance to the
access right from privilege 253
to 255 in SCOPE (refer to
Climatix SCOPE online help
End user
The access rights of this
level are suitable for users
who will operate the
These user levels are
password protected.
Service
The access rights of this
level are suitable for users
who will provide
maintenance to Climatix
OEM
Factory
The access rights of this
level are suitable for users
who will configure and
commission the Climatix
The specific access right for each user level can be defined by application engineer
The password related templates in SCOPE are listed in the following table, which
can be defined by application engineer in SCOPE.
Change factory password page
Change service password page
Change end user password page
After users enter one of these 5 pages from templates, press key INFO, and then it
will check if the title line of the corresponding templates has defined the target page
and if the current user level has enough privileges. If yes, it will redirect to the
defined target page. If not, it will redirect to the home page.
1. Press and hold key ROLL at any page (except the error report pages) with
OEM factory user level to go to the log in/off page as follows:
related