Siemens CU240B-2 - Page 30

Installing
3.3 Installing Control Unit
Converter with Control Units CU230P-2; CU240B-2; CU240E-2
30 Getting Started, 04/2014, A5E32885834B AB
Default setting 14: Switch over between fieldbus and motorized potentiometer
(MOP) using DI 3
Control Units CU230P-2 and CU240E-2
Selected with
• STARTER: Process industry with fieldbus
• BOP-2: Proc Fb
PROFIdrive telegram 20 Fieldbus interface is not active.
Default setting 15: Switch over between analog setpoint and motorized
potentiometer (MOP) using DI 3
Control Units CU230P-2 and CU240E-2
Selected with
• STARTER: Process industry
• BOP-2: Proc
Fieldbus interface is not active. Fieldbus interface is not active.