b. Front display
Change by clicking on the keys “Menu”, then ”5” and “1” on the device it will shown this menu
Figure 4-8 - Activation over Device menu
c. Via the use of DIGSI 4 for the hardware reset. This requires an Ethernet connection of DIGSI 4
with the device. Open the device with DIGSI online via Ethernet.
Click on “Restart” in the menu “Device”.
Note: A device restart will delete the content of all buffers. Please save the content before with
DIGSI 4 if this data are required for further analysis.
Figure 4-9 - firmware reset over DIGSI 4 with device restart
SCF 11/2008 V08.10 Page 14 of 29
To Next Page
Loading...
Need help?
General
