3.4 Functions for hot-runner
To operate with the protocol extension for hot-runners only a few additional
inputs and outputs are needed.
w
The operation of the automatic controller can be switched over from remote
to local operation. Therefore the inputs di1 to di3 or the F-key are available.
In local operation a start-/stop functionality can be achieved by switching on and
off the controller (for switching off put the set-point SP to OFF; for switching
on enter a valid set-point). The start command corresponds to the control
command (r) in the remote mode, the stop command to the control command (a).
Operation
Functions for hot-runner 10 Operating note KS 50-1 TCont
To Next Page
Loading...
Need help?
General
