System overview
9
Siemens Building Technologies 007995_a_en_--.doc
Fire & Security Products 04.2004
3.2 System configuration
Each fire detection system is configured individually. The configuration has an in-
fluence on the operation. The table below shows the configuration of your fire de-
tection system.
Parameters Functions and configuration
Operating access via password
via key switch
Remote transmission of alarms yes
no
Alarm sequence involving present staff yes
no
Switchover from 'Manned' to 'Unmanned' automatic
manual
automatic switchover time from 'Manned'
to ''Unmanned''
indicate
do not indicate
1. automatic switchover time from
'Manned' to ''Unmanned''
18:00
_____________
2. automatic switchover time from
'Manned' to ''Unmanned''
not activated
_____________
Delay period V1 ____ minutes
Delay period V2 ____ minutes
Switchover
summer time / winter time
automatic
manual
Remote transmission of faults yes
no
Function Evacuate activated
not activated
Access to Acknowledge always possible
only with password/key switch
Faults must be reset yes
no
Faults are always immediately transmitted
to the receiving station
yes
no
Manual call points in mixed detector
zones trigger alarm also when the detec-
tor zone is switched off
yes
no
Maximum operating time without mains
supply
______ h
Building plan handed over on: __________
by: _________
Tab. 1 System configuration
To Next Page
Loading...
Need help?
General
