GCNET and Galactic Voice 6-7
CHAPTER 6 | FIREFINDER-XLS INSTALLATION, OPERATION AND MAINTENANCE MANUAL
To select Galactic All Evac, follow the steps listed below.
1. Depress the Galactic All Evac switch.
2. The All Evac, Global All Evac, and all Speaker Group switch LEDs turn on
flashing red.
3. All speaker groups sound the Evac tone or message.
4. To end Galactic All Evac, depress the All Evac switch again.
5. The Evac signal turns off (assuming no automatic alarms exist).
6. The All Evac, Display Evac, and all Speaker Group switch LEDs turn off.
All Evac/Global All Evac 1/2
The All Evac 1/2 and Global All Evac 1/2 switches in the FCC VLinks sends, with a
single switch press, the Evac tone or message (predetermined in the system design)
to all speaker groups in the Building:
To select All Evac/Global All Evac, follow the steps listed below:
1. Depress the All Evac or Global All Evac 1/2 switch.
2. The All Evac, Global All Evac, and all Speaker Group switch LEDs in the
Building’s VLinks turn on flashing red.
3. All speaker groups sound the Evac tone or message.
4. To end All Evac, depress the All Evac or Global All Evac 1/2 switch again.
5. The Evac signal turns off (assuming no automatic alarms exist).
6. The All Evac, Global All Evac, and all Speaker Group switch LEDs turn off.
Selective Evac and Alert switches on FCCs only operate on Speaker Groups from the same
Building. Each Building must have its own Selective switch set on the FCC.
Select Evac 1/2
Select Evac sends the Evac tone or message (predetermined in the system design)
to selected local or remote speaker groups in the system. On an FCC, each VLinks
may be configured with a Selective Evac 1 and 2 for control of Speaker Groups within
the same Building’s VLinks.
To select Select Evac, follow the steps listed below:
1. Depress the Select Evac 1 and 2 switch in a VLinks, the LED flashes red.
2. Depress the desired individual Speaker Group switches in the same VLinks.
3. The selected Speaker Group and Display Evac switch LEDs flash red.
4. If no Speaker Group switches are pressed for 120 seconds, the system
automatically returns to normal.
5. The selected speaker groups sound the Evac tone or message.
6. To end Select Evac, first depress the selected Speaker Group switches,
then Select Evac.
To Next Page
Loading...
Need help?
General
