FS-250 PROGRAMMING MANUAL
5
Entering Alphanumeric Characters
Entry of alphanumeric data using keypad is as follows:
• Each character is entered using a two-keystroke sequence on the keypad.
• Numerals are entered using the sequence 0x, where x is the numeral to be
entered.
• Letters are entered using 1x, 2x, 3x, and 4x sequences, based on the letters
appearing above the numbers on the keypad, where the first digit is the position
of the letter, and the second digit is the key on which that letter appears. The
letter "Q" is entered using the sequence "27", as though "Q" appears on the "7"
between "P" and "R". "R" is entered as "37" and "S" as "47". Similarly, "Z" is
entered as "49", as though "Z" appears on the "9" key. Punctuation marks are
entered using 5x, 6x, 7x, and 8x sequences, as shown below:
CHARACTER SEQUENCE CHARACTER SEQUENCE
<space> 50 > 70
! 51 ? 71
" 52 @ 72
# 53 [ 73
$ 54 ¥ 74
% 55 ] 75
& 56 ^ 76
´ 57 _ 77
( 58 ` 78
) 59 { 79
* 60 | 80
+ 61 } 81
, 62 ? 82
- 63 ¦ 83
. 64
/ 65
: 66
; 67
< 68
= 69
Insert and overwrite modes can be toggled using the "C" key.
Entering the same letter into a position in overwrite mode will change the case of the
letter (i.e. if a position contains the letter "f", and the user enters "33" in overwrite
mode, the "f" will change to "F").
A character may be deleted by pressing the “9” key.
To Next Page
Loading...
Need help?
General
