Siemens FM 450-1 - Page 54

Step Options/procedure (X)
Assign the FM 450-1 pa‐
rameters
Specify the behavior of the digital outputs for counter 1
Output 1Q0 Disable
Active from comparison value 1 to over󹪞ow
Active from comparison value 1 to under󹪞ow
Active for "pulse duration" when comparison value 1 is
reached in up direction
Active for "pulse duration" when comparison value 1 is
reached in down direction
Active for "pulse duration" when comparison value 1 is
reached in up or down direction
Output 1Q1 Disable
Active from comparison value 2 to over󹪞ow
Active from comparison value 2 to under󹪞ow
Active for "pulse duration" when comparison value 2 is
reached in up direction
Active for "pulse duration" when comparison value 2 is
reached in down direction
Active for "pulse duration" when comparison value 2 is
reached in up or down direction
Pulse duration 0 to 500 ms
Specify the behavior of the digital outputs for counter 2
Output 2Q0 Disable
Active from comparison value 1 to over󹪞ow
Active from comparison value 1 to under󹪞ow
Active for "pulse duration" when comparison value 1 is
reached in up direction
Active for "pulse duration" when comparison value 1 is
reached in down direction
Active for "pulse duration" when comparison value 1 is
reached in up or down direction
Output 2Q1 Disable
Active from comparison value 2 to over󹪞ow
Active from comparison value 2 to under󹪞ow
Active for "pulse duration" when comparison value 2 is
reached in up direction
Active for "pulse duration" when comparison value 2 is
reached in down direction
Active for "pulse duration" when comparison value 2 is
reached in up or down direction
Pulse duration 0 to 500 ms
Commissioning
7.3 Working steps for parameter assignment
Counter module FM 450-1
54 Equipment Manual, 03/2022, A5E03648739-AC