Siemens FM 450-1 - Parameter Assignment; Chapter Overview; Installing and Calling Parameter Assignment Screen Forms

Parameter assignment
5
5.1 Chapter overview
Chapter overview
In this chapter you will learn how to install and start parameter assignment screen forms.
The parameter assignment screen forms have an integrated help function to support you with
parameter assignment and commissioning of the FM 450-1.
5.2 Installing and calling parameter assignment screen forms
Marginal conditions
The following conditions apply to the transfer of parameter assignment data to the CPU:
• STEP 7 must be correctly installed on your programming device.
• The programming device must be correctly connected to the CPU.
• The CPU must be in STOP
Note
During data communication via the MPI you must not pull out or plug in any S7-400 modules!
Installing the Parameterization Interfaces
To install the con󹪝guration package:
1. Place the supplied CD in the CD drive of your programming device or PC.
2. Start the program "Setup.exe".
3. Follow the operating instructions provided by the installation program.
Important information can be found in the readme 󹪝le.
Result
The components of the con󹪝guration package are installed in the following directories:
• SIEMENS\STEP7\S7LIBS\FMx501LIB:FCs, UDTs
• SIEMENS\STEP7\S7FCOUNT: Con󹪝guration software, Readme, Online Help
• SIEMENS\STEP7\EXAMPLES: Examples
• SIEMENS\STEP7\S7MANUAL\S7FCOUNT: Getting Started, Manuals
Counter module FM 450-1
Equipment Manual, 03/2022, A5E03648739-AC 37