16
Putting the mobile unit into service
Mobile unit operating hours (battery life):
These times are only achieved
after several charging and
discharging cycles
!
Permitted batteries:
Type
Standby mode
(hours)
When phone in use
(hours)
NiCd, 600 mAh
up to 70 up to 7
NiMH, 1100 mAh
up to 110 up to 11
NiMH, 1300 mAh
up to 130 up to 13
Nickel-Cadmium Nickel-Metal-Hydride
Saft RC6 Sanyo HR-3 U (1300 mAh)
Panasonic P-60 AA/1P GP GP120 AA HC
Philips R6 NC-P Emmerich CE R 6
UCAR RC6 Energizer EMH-1100 AAC
Energizer Eveready XC 6 Varta VH 1101 AA
DAIMON ACCU 1000
Sanyo N-3U
Varta Accu Plus Ni-Cd 1,2V
No. 5006
Instructions for the use of NiMH batteries:
After you have inserted the NiMH batteries, we recom-
mend that the mobile unit be fully charged and then dis-
charged until the battery warning beep is heard, i.e.
without replacing the batteries in the charging shell. This
ensures that the
charge status display
of the
mobile unit is adapted to the increased operating life of
the NiMH batteries.
You can subsequently place your mobile unit in the
charging shell each time it is used. Charging is
electron-
ically controlled
which ensures that the batteries are
charged optimally.
17
.
For information on setting the language,
see page 56.
Your system administrator supplies you with mobile units
that have already been logged on when you are installing
the system for the first time. You must log on any new
mobile units as described below if you extend the system.
● Please call Siemens Service if you purchased the mobile
unit
directly
from Siemens. Please call your
retailer
if
you did not purchase your mobile unit directly from Sie-
mens. Please ask Siemens Service or your retailer to pro-
vide you with the call number and the system code (eight-
digit) of every mobile unit and to open the "logon window"
(e.g. 10 minutes).
●
Logging
a mobile unit onto Hicom 150 E:
Switch the mobile unit on with the On/
Off key -
appears in the
display with the first logon procedure.
*
, for example, flashes with the
second logon procedure.
* See note "Base/system" on page 18
Press the menu key –
the main menu
is displayed
.
Scroll with the left display key until
is selected (in the top dis-
play line) and confirm the selection
with the right display key.
Scroll with the left display key until
is selected and confirm.
Confirm
*, for example, to log
on as system 1.
If necessary, select another base/
system with the display key.
is displayed
.
Logging mobile units onto a telephone system
Putting the mobile unit into service
18
Putting the mobile unit into service
e.g.
...
Enter the mobile unit system code
(eight-digit) and confirm the entry with
the display key –
✱
symbols are dis-
played instead of digits.
if necessary, press the display keys
and to correct an
entry.
*, for example, is displayed.
The mobile unit is successfully logged
on (registered) if the ring symbol
flashes (this can take up to 30 sec-
onds).
The mobile unit ready to receive or
transmit calls if this display is retained.
To Next Page
Loading...
