109
Setting recall Operating the base station on the PABX
Gigaset C470 IP / EN for AUS / A31008-M1916-C401-2-7619 / settings_bs_hs_pabx.fm / 17.12.07
Version 2.1, 08.01.2007
Operating the base station on the PABX
The following settings are only necessary when your PABX requires them; see the PABX
user guide. The settings only concern fixed line network connections.
You cannot send or receive SMS messages on PABXs that do not support Calling Line Iden-
tification.
Setting recall
You can set the recall option.
v ¢ Ð Settings ¢ Telephony ¢ Fixed Line ¢ Recall
q Select recall and press §OK§.
The current setting is indicated by .
a Press and hold (idle status).
Setting pauses
Changing pause after line seizure
You can set the length of the pause inserted between pressing the talk key c and sending
the phone number.
v55O L
~ Enter a number for the length of the pause (1 = 1 sec.; 2 =3sec.; 3 =7sec.)
and press
§OK§.
Changing the pause after the recall key
You can change the length of the pause if your PABX requires this (refer to the user guide
for your PABX).
v55O
~ Enter a number for the length of the pause (1 = 1 sec.; 2 = 2 sec.; 3 = 3 sec.;
4 = 6 sec.) and press
§OK§.
Switching temporarily to touch tone dialling (DTMF)
If your PABX still operates with dial pulsing (DP), but you need touch tone dialling for a con-
nection (e.g. to listen to the network mailbox for your fixed line network) you must switch
to touch tone dialling for the call.
Precondition: You are currently conducting an external call via the fixed line network or
you have dialled an external fixed line network number or an external call is signalled.
§Options§ Open menu.
Tone Dialing Select and press §OK§.
Touch tone dialling is now activated for this call only.
‰
To Next Page
Loading...
