100
Web configurator
Gigaset S450 IP LBA / IM-Nord_en / A31008-M1713-R221-2-7619 / web_server.fm / 28.3.07
Version 4, 16.09.2005
Starting firmware update
Preconditions:
u No calls are being made via the fixed
network or VoIP.
u There is no internal connection
between the registered handsets.
u The base station menu is not open in
any of the handsets.
¤ Click on Update Firmware.
The firmware is updated. This process can
take up to 3 minutes.
Activating/deactivating the
automatic version check
When the version check is activated, the
phone checks on a daily basis whether the
Siemens configuration server is carrying a
new version of the phone firmware or of
the file with the general settings for your
VoIP provider.
If a new version is available, a notification
is sent to the handset and the message key
flashes. You can then carry out an auto-
matic update of the firmware (page 66) or
of the VoIP provider settings (page 67).
¤ Open the following Web page:
Settings
¢ Miscellaneous.
¤ Click on the Yes option next to Auto-
matic check for software/profile updates to
activate the automatic version check.
Click on No if you do not want a version
check to be carried out.
¤ Click on Set to save the changes.
Activating VoIP status message
display
Display VoIP status messages on your
handset when there are VoIP connection
problems. These messages give you infor-
mation on the status of a connection and
contain a provider-specific code that helps
the service team when they are analysing
the problem.
¤ Open the following Web page:
Settings
¢ Miscellaneous.
¤ Click on the Yes option after Show VoIP
status on handset to activate status mes-
sage display
If you click on No, no VoIP status mes-
sages are displayed.
¤ Click on Set to save the changes.
Please note:
You can also start the firmware update on the
handset (page 66).
Please note:
A table with possible status codes and their
meaning can be found in the Appendix on
page 105.
To Next Page
Loading...
