Siemens Gigaset S450 IP - Operating the Base Station; On the PABX; Setting the Flashing Time; Setting Pauses

70
Operating the base station on the PABX
Gigaset S450 IP LBA / IM-Nord_en / A31008-M1713-R221-2-7619 / settings_bs_hs_pabx.fm / 28.3.07
Version 4, 16.09.2005
Operating the base station
on the PABX
The following settings are only necessary
when your PABX requires them; see the
PABX user guide. The settings only con-
cern fixed network connections.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.
Setting the flashing time
You can set the flashing time.
v ¢ Ð Settings ¢ Telephony
¢ Fixed Line ¢ Recall
q Select flashing time and press
§OK§.
The current language is indicated by ½.
a Press and hold (idle status).
Setting pauses
Changing pause after line seizure
You can set the length of the pause
inserted between pressing the talk key
c and sending the phone number.
v55O1L
~ Enter a number for the length
of the pause (1 = 1 sec.;
2 =3secs.; 3 = 7 secs.) and
press
§OK§.
a Press and hold (idle status).
Changing the pause after the recall key
You can change the length of the pause if
your PABX requires this (refer to the user
guide for your PABX).
v55O11
~ Enter a number for the length
of the pause (1 = 1 sec.;
2 =2secs.; 3 = 3 secs.;
4 = 6 secs.) and press
§OK§.
a Press and hold (idle status).
Switching temporarily to
tone dialling (DTMF)
If your PABX still operates with dial pulsing
(DP), but you need touch tone dialling
(DTMF) for a connection (e.g. to listen to
the network mailbox) you must switch to
touch tone dialling for the call.
Precondition: You are currently conduct-
ing an external call via the fixed network
or you have dialled an external fixed net-
work number or an external call is sig-
nalled.
§Options§ Open menu.
Tone Dialing Select and press §OK§.
Touch tone dialling is now activated for
this call only.