7
Setting up the telephone for use
Gigaset S645 / GBR / A31008-M1634-L101-1-7619 / starting.fm / 27.08.2004
Connecting the base station
¤ First connect the power supply unit
and then the phone jack as shown
below and place the cables in the cable
recesses.
1 Underside of the base station (section), the
charger is not illustrated
2 Power supply unit 230 V
3 Phone jack with phone cord
Please note:
u The power supply unit must always be
plugged in because the telephone
does not work without a mains connec-
tion.
u If you buy a phone cable from a retailer,
pay attention to the wiring of the
phone jack.
Your phone is now ready to use!
You can now use the handsfree unit to
make a phone call directly on the base sta-
tion.
The answering machine is switched on
with a standard announcement.
The base station is assigned the internal
number 0 and the internal name INT 0.
Setting up the handset for use
Inserting the battery
¤ Insert the batteries the right way round
(see figure).
The polarity is indicated in or on the bat-
tery compartment.
Correct phone jack
1unused
2unused
3a
4b
5unused
6unused
1
3
2
1
1
1
3
2
1
4
5
6
Note:
You can make individual settings on the base
station (e.g. date and time).
Caution:
Use only the rechargeable batteries recom-
mended by Siemens on page 64! Never use
a conventional battery (non-rechargeable)
or other battery types as this may cause signif-
icant damage to health and property.
For example, the jacket of the battery could
be destroyed or the battery could explode.
The phone could also malfunction or be dam-
aged as a result of using batteries that are
not of the recommended type.
To Next Page
Loading...
