63
Configuring the Advanced Settings
Gigaset SE361 WLAN / deutsch / A31008-M1067-R101-1-7619 / configure_router.fm / 07.09.2006
Schablone 2004_12_27
If WDS is activated the page shows the WDS client with the highest signal strength
(access point or repeater) to which your Gigaset SE361 WLAN is able to connect.
The following information is displayed:
– the MAC address of the repeater is shown in the MAC address field.
– the SSID is shown in the SSID field.
– the radio channel used for data transfer is shown in the Channel field.
–the Signal strength shows the strength of the connection to the repeater in per-
centage terms.
ì Enter a description that will help you to identify different access points / repeaters in
the Comment field.
ì To update the display click on Refresh. If there is a access point / repeater with
higher singnal strenght close to your Gigaset SE361 WLAN, it is displayed.
ì Apply the settings by clicking OK.
Note:
In order to use WDS (Wireless Distribution System), you have to change your wireless
encryption setting. Only WEP is supported for WDS. If WPA2-PSK / WPA-PSK is selected
as encryption method an error message is output.
To Next Page
Loading...
