18
4.Insert the door panel into the guide with both hands. (Fig. D).
5.Push the door panel downwards, lift it slightly and hook it in
at the top. (Fig. E).
Make sure that the door panel is sitting flush with the control
panel.
6.Fully open the door, while holding the panels firmly with one
hand. (Fig. F).
7.Push the door downwards again and tighten the screws
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. G).
Note: The oven may only be used again when the panels are
correctly installed.
Malfunction table
Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
ã=Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
Malfunction table
Problem Possible cause Remedy/information
The appliance does not work. Defective fuse Look in the fuse box and check that the circuit
breaker is in working order.
Plug not plugged in Plug it in.
Power cut Check whether the kitchen light works.
“Set clock” appears in the status
bar. The time displayed is not the
current time. “Select language”
appears in the settings area on the
right.
Power cut Turn the rotary selector to set the correct time
then press the
0 button. The language set
remains unchanged following a power cut.
The oven door cannot be opened.
“Set clock” appears in the status
bar. The time displayed is not the
current time. “Select language”
appears in the settings area on the
right. The
H symbol is displayed.
Power cut during self-cleaning operation Turn the rotary selector to set the correct time
then press the
0 button. The language set
remains unchanged following a power cut.
Wait until the cooking compartment has
cooled down. The
H symbol goes out. You
can open the oven door again.
The oven does not heat up.
“Demo” is displayed in the status
bar.
The oven is in demo mode Switch off the circuit breaker in the fuse box
and then switch back on after approx.
20 seconds. Within the next 2 minutes, press
and hold the
@ button for four seconds until
“Demo” disappears from the status bar.
The oven does not heat up or the
type of heating selected cannot be
set.
Type of heating not recognised. Set once again.
“Automatic switch-off” appears in
the status bar.
Automatic switch-off has been activated. The
oven switches off.
Press any button. The text disappears. You
can make settings again.
To Next Page
Loading...
