Operating the appliance en
15
4. After calibration, allow the appliance to heat up.
Caution!
Enamel damage
Do not start an operation if water is on the cooking
compartment floor. Before the operation, wipe the
water from the cooking compartment floor.
5. Dry the cooking compartment floor.
6. Set the type of heating and temperature for heating
up, then start the appliance operation.
7. Keep the kitchen ventilated while the appliance is
heating up.
8. Stop the appliance operation after the indicated
duration. Press the On/Off button to switch off the
appliance.
9. Wait until the cooking compartment has cooled
down.
10. Clean the smooth surfaces with soapy water and a
dish cloth.
11. Empty the water tank and dry the cooking
compartment. ~ "After every steam operation"
on page 19
Notes
■ So that the appliance adapts to a new installation
location after moving house, reset the appliance to
the factory settings. Repeat the initial use settings
and the calibration.
■ The appliance saves the calibration settings, even in
the event of a power cut or disconnection from the
mains. The calibration must not be repeated.
Cleaning the accessories
Clean the accessories thoroughly using soapy water
and a dish cloth or soft brush.
1Operating the appliance
Operating the appliance
You have already learnt about the controls and how
they work. Now we will explain how to set your
appliance. You will learn about what happens when you
switch the appliance on and off, and how to select the
operating mode.
Switching the appliance on and off
Before you are able to set the appliance, you must
switch it on.
Exception: The childproof lock and the timer can be set
when the appliance is switched off.
Displays or information, e.g the residual heat indicator
in the cooking compartment, remain visible in the
display after the appliance has been switched off.
Switch off your appliance when you do not need to use
it. If no settings are applied for a long time, the
appliance switches itself off automatically.
Switching the appliance on
Use the On/Off button to switch the appliance on.
The on/off symbol above the button is illuminated in
blue.
The Siemens logo appears in the display, and then a
type of heating and a temperature.
Note: You can specify which operating modes should
appear after the appliance is switched on in the basic
settings.
Switching off the appliance
Use the On/Off button to switch off the appliance.
The lighting above the button goes out.
A set function is cancelled.
The time appears in the display.
Note: You can set whether or not the time should be
displayed when the appliance is switched off in the
basic settings.
Starting or interrupting operation
To start operation or to interrupt an operation which has
started running, press the Start/Stop button. The
cooling fan may continue to run after an operation is
interrupted.
Press the On/Off button to delete all settings.
If you open the cooking compartment door during
operation, operation is interrupted. Close the cooking
compartment door to continue operation.
Heating up
Type of heating Top/bottom heating %
Temperature 240 °C
Duration 30 minutes
To Next Page
Loading...
