Siemens iQ500 HR578G5 6B Series - Attaching Shelf Supports; Removing Pull-Out Rail; Attaching Pull-Out Rail

Shelf supports en
29
2.
Push the rail into the front socket
⁠ until the rail
also rests against the cooking compartment wall,
and then press this downwards ⁠.
3
4
20.3 Removing the pull-out rail
WARNING‒Risk of burns!
The shelf supports get very hot
▶ Never touch the shelf supports when hot.
▶ Always allow the appliance to cool down.
▶ Keep children at a safe distance.
Notes
¡ Depending on the appliance type, you must change
the basic settings for the telescopic rails for appli-
ances with rails and pull-out rails.
→"Basic settings", Page21
¡ If necessary, you can use pull-out rails on all levels.
1.
Push on the tab marked PUSH behind the rail, and
push the rail to the rear.
2.
Keep the PUSH tab pushed back ⁠ and swing the
rail outwards ⁠.
3.
Pull the rail out towards the front until the retainer at
the back unhooks.
4.
Remove the pull-out rail.
5.
Clean the pull-out rail.
→"Cleaning products", Page24
20.4 Attaching the pull-out rail
Note:The pull-out rails only fit on the right or left. Make
sure when you fit them that you can pull them out to-
wards the front.
1.
Insert the pull-out rail between the two bars.