Siemens iQ500 HR578G5 6B Series - Descaling Indicator Troubleshooting; Steam System Issues; Home Connect Connectivity Problems; Replacing Oven Light Bulb

Disposal en
35
Fault Cause and troubleshooting
⁠ lights up in the dis-
play.
Build-up of limescale in the appliance.
▶
Run the descaling programme in full.
→"Descaling", Page27
⁠ ⁠ ⁠ appears in the
display.
The power supply has been disconnected or the appliance has been switched off during the
descaling process.
▶
Run the interrupted descaling programme in full.
→"Descaling interrupted", Page28
The appliance hums
during operation and
after it is switched off.
Functional test of the pump creates operating noise.
No action required.
During operation with
steam assistance,
steam escapes from
the ventilation slots.
Steam escapes for physical reasons.
▶
Wait until the cooking with steam assistance ends.
After the end of cooking with steam assistance, no more steam will escape after a short
time.
After using the steam
assistance, the cook-
ing result is too dry
or too moist.
Steam intensity set incorrectly.
▶
Set a higher or lower steam intensity.
HomeConnect is not
working properly.
Different causes are possible.
▶
Go to www.home-connect.com.
22.2 Replacing the oven light bulb
If the light in the cooking compartment fails, change
the oven light bulb.
Note:Heat-resistant, 40-watt, 230 V halogen bulbs are
available from the after-sales service or specialist retail-
ers. Only use these bulbs. Hold the new halogen bulbs
only with a clean, dry towel. This increases the service
life of the bulb.
WARNING‒Risk of burns!
The appliance and its parts that can be touched be-
come hot during use.
▶ Caution should be exercised here in order to avoid
touching heating elements.
▶ Young children under 8 years of age must be kept
away from the appliance.
WARNING‒Risk of electric shock!
When changing the bulb, the bulb socket contacts are
live.
▶ Before replacing the bulb, ensure that the appliance
is switched off in order to prevent a potential electric
shock.
▶ Also unplug the appliance from the mains or switch
off the circuit breaker in the fuse box.
Requirements
¡ The appliance is disconnected from the power sup-
ply.
¡ The cooking compartment has cooled down.
¡ You have a new halogen bulb to replace the old one.
1.
Place a tea towel in the cooking compartment to
prevent damage.
2.
Turn the glass cover anti-clockwise to remove it
⁠.
3.
Pull out the halogen bulb without turning it ⁠.
4.
Insert the new halogen lamp and press it firmly into
the socket.
Make sure the pins are positioned correctly.
5.
Depending on the appliance model, the glass cover
may have a sealing ring. Put the sealing ring in posi-
tion.
6.
Screw the glass cover on.
7.
Take the tea towel out of the cooking compartment.
8.
Connect the appliance to the power supply.
23 Disposal
23.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
1.
Unplug the appliance from the mains.
2.
Cut through the power cord.
3.
Dispose of the appliance in an environmentally
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.