EasyManua.ls Logo

Siemens iQ700 HM976GM 1B Series - Appliance Installation Instructions; General Installation Guidelines

Siemens iQ700 HM976GM 1B Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
en Installation instructions
48
Recommended settings for defrosting food using the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Meat Uncovered cook-
ware
2 - 1. 180
2. 90
1. 5
2. 10-15
Recommended settings for cooking food using the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Custard Uncovered cook-
ware
2 - 1. 360
2. 180
1. 20
2. 20-25
Sponge Uncovered cook-
ware
2 - 600 7-9
Meat loaf Uncovered cook-
ware
2 - 600 22-27
Recommended settings for cooking in combination with the microwave
Food Accessory/cook-
ware
Shelf pos-
ition
Type of
heating
→Page11
Temperature in
°C
Microwave
power setting
in W
Cooking
time in
mins
Potato gratin Uncovered cook-
ware
2 170-190 360 25-30
Cakes Uncovered cook-
ware
2 180-200 180 18-23
Chicken Pan support 2 200-220 360 25-35
1
1
Turn the dish 2/3 of the way through the cooking time.
Installation instructions
31  Installation instructions
Observe this information when installing the appliance.
 31.1 General installation instructions
Follow these instructions before you start in-
stalling the appliance.
¡ The installation cabinet must not have a
back panel behind the appliance. There
should be a gap of at least 35mm
between the wall and the cabinet base as
well as the rear panel of the cabinet situ-
ated above.
¡ Ventilation slots and intake openings must
not be covered.
¡ The safe operation of this appliance can
only be guaranteed if it has been installed
to a professional standard in accordance
with these installation instructions. The in-
staller shall be liable for damages incurred
as a result of incorrect installation.
¡ Do not use the door handle for the trans-
port or installation.
¡ Check the appliance for damage after un-
packing it. Do not connect the appliance if
it has been damaged in transit.
¡ Before starting up the appliance, remove
any packaging material and adhesive film
from the cooking compartment and the
door.
¡ Proceed in accordance with the installation
sheets for installing accessories.
¡ Fitted units must be heat-resistant up to
95°C, and adjacent unit fronts up to
70°C.
¡ Do not install the appliance behind a decor-
ative door or the door of a kitchen unit.
There is a risk of overheating.

Table of Contents

Related product manuals