Siemens LME39.400C2 - Changing the Oems Password

58/73
Building Technologies Division Basic Documentation LME39… CC1P7106en
19 Parameter level 08.12.2017
19.3 Changing the OEM’s password
Parameter 042: flashes.
Press
/
reset
to go to level c: for password changes.
/
reset
Letter c: for confirmation appears flashing.
Proceed as described in section Entering the password
and enter the former password.
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
/
reset
Letter n: for new appears flashing.
Proceed as described in section Entering the password
and enter the new password (5 characters).
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
/
reset
Letter r: for repeat appears flashing.
Proceed as described in section Entering the password
and repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
/
reset
.
7782z98/0416
SEt confirms that the new password has been saved.
Parameter 042: flashes again.