Siemens LME73 - Fault Status Messages, Display of Errors and Info; Display of Errors (Faults) with Lockout; Reset

59/106
Building Technologies Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 17.04.2018
13.4.1.4. Fault status messages, display of errors and info
Display of errors (faults) with lockout
P
Vh
min
s%
Bild185/1107
Display shows Loc:. The bar under the fault status
message appears.
Unit is in the lockout position.
The current error code is displayed (see chapter Blink
code table).
Example: Error code 7
Reset
/reset
1 s
When pressing
/reset
for 1 second, rESEt appears on the
display.
When the button is released, the basic unit is reset.
/reset
<3 s
P
Vh
min
s%
Bild21/0707
P
Vh
min
s%
Bild22/0707
When pressing
/reset
for >3 seconds, the display shows
InFo, SEr and then OPErAtE.
When the button is released, the basic unit is reset.
Β
Note:
For meaning of the error and diagnostic codes, see chapter Error code list…
When an error has been acknowledged, it can still be read out from the error history.