Siemens LME73 - Changing the Oems Password

73/106
Building Technologies Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 17.04.2018
13.8.3 Changing the OEM's password
Parameter 042: blinks.
Press
/reset
to go to level c: for password changes.
/reset
Letter c: for confirmation appears blinking.
Proceed as described in section Entering the password
and enter the former password.
After entry of the last character, the password must be
confirmed by pressing
/reset
.
/reset
Letter n: for new appears blinking.
Proceed as described in section Entering the password
and enter the new password (5 characters).
After entry of the last character, the password must be
confirmed by pressing
/reset
.
/reset
Letter r: for repeat appears blinking.
Proceed as described in section Entering the password
and repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
/reset
.
7782z98 /0416
SEt confirms that the new password has been saved.
Parameter 042: blinks again.