Opdimar Register 8 SPB7-230.101.03 Page 2 of 2 Siemens AG
Maintenance Instructions Rev. 04 07.03 CS PS 24 Medical Solutions
3 - 2 System
PMP Scsi cables, cd-rom
It is important to check that the SCSI cables are properly connected and the hardware is
right terminated. If not, this might generate a lot of problems e.g. failure to write images to
MO disk, corrupted MO disk, corrupted hard disk.
• Make sure the SCSI cabling is properly connected, and fixed, to the units and that the
cable is not bent too much just behind the MO.
• The MO drive shall be terminated with the external termination plug.
If the system not have been able to store images on the MO disk due to above problem, it
will take longer to save images when the system can save.
PMP Cables general
• Check connectors and cables between biopsy controller and CCD camera.
• Check connectors and cables between biopsy controller and workstation.
• Check that all cables are free from damages, especially monitor cables.
• Check that connectors are properly fixed.
SW Disk cache settings
For instructions how to check the disk cache settings see
Service Instructions for
Opdima
r
, chapter
Disk cache settings
.
SI Biopsy unit
This unit contains the following safety-relevant parts, which should be checked every year
and, if required, replaced:
• Biopsy unit connectors (25 pin DSUB connector and 9-pin object table connector). Visual
inspection.
• Sliding pads on the underside of the biopsy unit object table. Check that the sliding pads
are free from visual damages and that the biopsy unit object table runs smoothly on the
base plate.
• Check that the biopsy unit is safely locked to the MAMMOMAT.
It is important not to interrupt the system when it is saving
images on the MO disk, the MO disk can be destroyed.
CAUTION
To Next Page
Loading...
