Siemens MAMMOMAT 1000 - Test; Calibrations; Checks

Testing 4 - 1
Siemens AG Register 8 SPB7-230.101.03 Page 1 of 2 Opdimar
Medical Solutions Rev. 04 07.03 CS PS 24 Maintenance Instructions
4Testing
4.1 Test
PMF Test of units
For instructions how to test the units see Service Instructions for Opdima r , chapter Test of
units
.
4.2 Calibrations
PMF CCD-Camera calibration
For instructions how to calibrate the CCD-Camera see Service Instructions for Opdima r ,
chapter
CCD camera calibration and maintenance .
Q Calibration of the biopsy unit
• Check biopsy accuracy according to Service Instructions for Opdima r , chapter Verifying
the calibration of the biopsy unit
. Verify the calibration for all four target points of the
stereo calibration phantom.
• If biopsy accuracy is not satisfactory, perform calibration according to Service
Instructions for Opdima
r , chapter Calibration of the biopsy unit .
4.3 Checks
QIQ Opdimar AEC
For instructions how to check Opdimar AEC see Service Instructions for Opdima r ,
chapter
Check of Opdima AEC .
QIQ Resolution
For instructions how to check resolution see Service Instructions for Opdima r , chapter
Check of resolution .