Configuring data in Asset Manager
7.3 Adding a datasource and datapoints
Getting Connected to MindSphere
Getting Started, 05/2018 61
5. Enter datapoint data.
Note
• The units and data types specified here will need to match exactly with the aspects
and variables. If they are different, the aspect cannot be connected to the datapoint.
• The protocol datatypes specify the Datapoint Address. You can find additional
information on protocol datatypes in the chapter Overview of datatypes.
6. Confirm with "Accept".
7. To save the added datapoint in "Edit Mode" click "Save".
Result
The new datapoint is available at the datasource.
To Next Page
Loading...
Need help?
General