33
pause between tap changes for this amount of time (in seconds)
when in auto mode motor stays on for exactly RLOnTime
seconds
timeout for tap changer motor running when no operation count
occurs.
defines the operations count signal input line (1 = U10, 2 = HS)
defines the operations counter type (1 = toggle, 2 = pulse)
defines the minimum amount of time that an operations count
signal must be present in order for the operations counter to
increment (applies to pulse type operations counters only)
defines the neutral signal input line (1 = U12, 2 = U112, 3 =
NONE)
number of neutral positions
Voltage setpoint level for reverse power flow
Bandwidth voltage reverse power flow
Control intentional time delay (in s) for reverse power flow
Line drop voltage due to line resistance component (reverse
flow)
Line drop voltage due to line reactive component (reverse flow)
Voltage reduction control mode
Alternate time delay for voltage reductions (in seconds)
VRC1 contact configuration
VRC2 contact configuration
MJ-X or MJ-3A emulation mode
Voltage reduction first stage (in %)
Voltage reduction second stage (in %)
Voltage reduction third stage (in %)
VRC setting #1 for Auto VRC (in %)
VRC setting #2 for Auto VRC (in %)
Load current #1 for Auto VRC (in %)
Load current #2 for Auto VRC (in %)
Condition C1: depending on the tap-change method, at least one of the two controls, TapChg or TapPos shall be
used for manual operation. BndCtrChg may be optionally used to change the value of BndCtr by commands.
To Next Page
Loading...
