Siemens MJ-XL User Manual (English)

Other manuals for Siemens MJ-XL

Installation And Operation Manual86 pages

Questions and Answers:

A
Angel JonesAug 16, 2025
What to do if Siemens Control Panel shows Overcurrent?
- B
  Brenda JohnsonAug 16, 2025
  If the Siemens Control Panel displays 'Overcurrent', ensure that the alert disappears when an in-range current (0-200 mA) is applied at C2/E1.
P
pcooperAug 19, 2025
How to troubleshoot Low Current on a Siemens MJ-XL Control Panel?
- C
  Christina CrawfordAug 19, 2025
  If the Siemens Control Panel shows 'Low Current', check the E1 and C2 wiring and the calibration on the Current inputs. You may also request the MJ-X[L] Troubleshooting Guide from your Siemens PT & D representative.
S
Scott CallahanAug 22, 2025
How to fix High Voltage on Siemens Control Panel?
- B
  Benjamin ClarkAug 22, 2025
  If the Siemens Control Panel displays 'High Voltage', perform calibration.
D
David OneillAug 25, 2025
What to do if Siemens Control Panel shows Low Battery?
- S
  Scott SimsAug 26, 2025
  If the Siemens Control Panel displays 'Low Battery', check that the battery was installed properly. If the fault persists, consult the factory.
J
jamie05Aug 28, 2025
What to do if Siemens MJ-XL Control Panel shows R Limit Reached or L Limit Reached?
- D
  Damon AbbottAug 28, 2025
  If the Siemens Control Panel displays 'R Limit Reached' or 'L Limit Reached', verify that the MJ-X can automatically raise and lower the tap position.
K
Karl LeblancAug 30, 2025
How to troubleshoot Tap Pos ???? on Siemens MJ-XL?
- K
  Karen DelgadoAug 31, 2025
  If the Siemens Control Panel displays 'Tap Pos ????', check the Neutral (PDS-U12) and Operations Counter (PDS-U10) inputs.
J
juliejimenezSep 3, 2025
What does Not in Auto mean on Siemens MJ-XL Control Panel?
- K
  Kathleen BeardSep 3, 2025
  The 'Not in Auto' message on the Siemens Control Panel indicates that the Remote/Auto/Manual switch is in Manual.
R
Ryan HaneySep 5, 2025
How to fix Neutral Sig. Err on Siemens MJ-XL?
- G
  Gina HoodSep 6, 2025
  If the Siemens Control Panel displays 'Neutral Sig. Err', check the Neutral (PDS-U12) input.
R
ramirezcrystalSep 9, 2025
What does Auto Inhibit mean on Siemens Control Panel?
- J
  John JonesSep 9, 2025
  The 'Auto Inhibit' alert on the Siemens Control Panel does not indicate a fault condition. It indicates that Automatic Inhibit has been activated either via the communications link or via the Automatic Inhibit Input terminals.
T
Tina SheltonSep 12, 2025
How to troubleshoot Tap Track Error on Siemens MJ-XL?
- K
  Kyle SingletonSep 12, 2025
  If the Siemens Control Panel displays 'Tap Track Error', check PDS signals J, K, U10 and U12.