Siemens NCU 710.3 PN - Mounting; Connection; Interface Overview

Connectable components
9.3 PP 72/48D 2/2A PN
NCU 7x0.3 PN
118 Manual, 09/2011, 6FC5397-1EP40-0BA0
9.3.3 Mounting
The I/O module can be fastened to the wall of the control cabinet using a mounting plate.
The module must be installed according to EN 60204.
Mounting versions:
● Portrait mounting at the lateral strap of the mounting plate (2x M5 or M6 screws).
● Flat mounting at the rear wall of the mounting plate (4x M5 or M6 screws).
WARNING
A protective conductor must be connected using the grounding screw.
9.3.4 Connection
9.3.4.1 Interface overview
2UGHUQR
3UHIDEULFDWHGFDEOHV
3RZHUVXSSO\
9'&
7HUPLQDOVWULSFRQYHUWHU
'LJLWDO,2
5LEERQFDEOH
;352),1(7 3RUWVDQG
&RQQHFWLQJFDEOHPD[P
$QDORJLQSXWVPD[
$QDORJRXWSXWVPD[
$QDORJ,2
33'$31
;
;
;
;
1&8[31
33'31
33'$31
0&3&&31
);'&
;
Figure 9-16 Connection options of the PP 72/48D 2/2A PN I/O module