Making calls with multiple lines
127
Step by Step
Line preview
Activating via the line keys
Prerequisite: You are already on a call on one line and a
further call rings on the secondary line. Service person-
nel have activated line preview.
T Press the flashing trunk key. A popup window opens
and you receive information about the caller.
T Press the flashing line key to answer the second call.
Activating via preview key
Prerequisite: You have programmed a sensor key with
the "Preview"Æ page 69 . Your service personnel have
activated the preview function.
Preview for a call:
You are already conducting a call on one line. A further
call rings on a secondary line.
S Press the "Preview" sensor key. A popup window
opens and you receive information about the caller.
R Press the "Preview" sensor key again to hide the pre-
view or wait until the popup closes itself after a speci-
fied period of time.
Permanent preview
S Press the "Preview" key in idle mode. This way the pre-
view for all lines with "preview mode" remains active un-
til you press the "Preview" sensor key again.
If service personnel have deactivated the line
preview, a call is answered immediately on a sec-
ond line when the line key is pressed, without
showing caller information.
To Next Page
Loading...
Need help?
General