Need help?Do you have a question about the Siemens PS2 and is the answer not in the manual?
General| Supply Pressure | 1.4 to 7 bar (20 to 100 psi) |
|---|---|
| Hazardous Area Certification | ATEX, IECEx, FM, CSA |
| Type | Electropneumatic |
| Input Signal | 4 to 20 mA |
| Enclosure Rating | IP66/NEMA 4X |
| Communication | HART |
Lists essential tools for mounting the older linear actuator.
Illustrates the hardware mounting for the old style linear actuator.
Details hole patterns for different actuator sizes and travels.
Lists tools and initial steps before connecting the actuator.
Step-by-step guide for mounting the PS2 positioner on linear actuators.
Diagrams and instructions for aligning feedback arm and mounting brackets.
Lists tools and outlines the procedure for mounting PS2 on rotary actuators.
Visual guides for mounting the PS2 on different rotary actuator models.
Step-by-step guide for mounting the PS2 onto quarter-turn actuators.
Illustrates mounting and lists parts for quarter-turn actuators.
Explains the PS2 positioner's display and physical control buttons.
Details the Automatic, Manual, Configuration, and Diagnostic modes.
Guide for attaching the positioner and connecting to air and mA signals.
Detailed steps for calibrating the positioner for linear actuators.
Steps for setting up and calibrating the positioner for rotary actuators.
Procedures to reset the positioner to factory default settings.
Details on adjusting the transmission ratio selector for valve control.
Guide on navigating modes and changing input levels on the PS2 display.
Comprehensive list and explanation of PS2 positioner parameters.
Procedure for setting and locking the sliding clutch torque.
Instructions on how to lock the gear ratio setting for stability.
Troubleshooting common problems like valve not actuating or hunting.
Solutions for issues like incorrect valve movement or rapid actuation.
Contact details and addresses for Dyna-Flo service centers.
To Next Page