98 | Part 3
■ M181 TURRET CCW ROTATION
Command
M181 can be used as sole command before commanding T-code. In addition, it can
be used in the same block with T-code. It is one-shot M-code.
Function
When tool index is progress in automatic mode, it will rotate in the direction of
CCW(in the front turret) not a short distance. If tool index is done, the next tool index
rotates in the direction of short distance.
Rotate turret in the direction of CCW.
However, above command is not modal. Once tool index is done, the method of tool
index returned its original way of short distance direction.
■ M211 MAIN SPINDLE COOLANT BLOW ON
Function
Operate coolant blow.
■ M212 MAIN SPINDLE COOLANT BLOW OFF
Function
Stop the coolant blow in operating.
To Next Page
Loading...
