PROGRAMMING | 97
■ M127 STRADDLET TOOL UNCLAMP
• Function
Unclamp Straddle Tool.
• Completion of Command
M-code will be finished after the time set in TM26 passed by.
• Condition of Function
In the case that straddle tool is used, the machine is Gang Type and alarm
relating to T-code, Tool does work.
■ M132 OIL MIST COLLECTOR ON
Function
Run the Oil Mist Collector.
■ M133 OIL MIST COLLECTOR OFF
Function
Stop the Oil Mist Collector.
■ M138 COOLANT FLUSHING ON
Function
Run the coolant flushing.
■ M139 COOLANT FLUSHING OFF
Function
Stop the coolant flushing.
■ M180 TURRET CW ROTATION
Command
M180 can be used as sole command before commanding T-code. In addition, it can
be used in the same block with T-code. It is one-shot M-code.
Function
When tool index is progress in automatic mode, it will rotate in the direction of CW(in
the front turret) not a short distance. If tool index is done, the next tool index rotates in
the direction of short distance.
Rotate turret in the direction of CW.
However, above command is not modal. Once tool index is done, the method of tool
index returned its original way of short distance direction.
To Next Page
Loading...
