Siemens PUMA V8300/M - Page 120

112 | Part 3
** Drilling, Tapping cutting additional description
If tool draws only small load such as small drill(tap), it may be still within normal load range which
case TLM(Tool Load Monitoring) cannot detect this situation.
-. Reset Tool Data : Delete
Tool data at data number
-. Calculate Default : Calculate
Min/Max current value
which contain Tolerances
(Refer to Expert setting)
-. Assign Data set : Specify
number of data set
(at Tool enable set screen)
-. Copy/Paste : Copy/Paste
Measured value for sister
tool
-. << : Soft key extend
(soft key button 1)
-. Back : Screen EXIT