Siemens PUMA V8300/M - Page 119

PROGRAMMING | 111
-. Direction : Axis Direction to measure
-. Reference : Plane select for detection
axis
-. G0/G01 : Detection feed selection
-. G2/G3 : Detection Circular interpolation
selection
-. G331/G332 : Detection Tapping
advance/retraction selection
-. G33 : Detection Thread cutting selection
-. Stand Still : If axis is not moved during
real cutting, can be set.
-. Dis.to Go/Dis. To Start : for detection
Min current at Drilling cutting.
(Refer to Distance to Go/Start section)
-. Moving Direction : Geometry axis
direction of cutting for Dist.to Go/Dist. to
Start(Refer to Distance to Go/Start section)
-. OEM 1.2.3 : Specified G code by user.
>> OEM G code specify at expert screen
-. Tool +,- : Tool selection
-. Active Tool : current tool
-. Change Magazine :
Magazine selection
- Edge +,- : Edge selection
-. >> : Soft key extend
(soft key button 2)
-. Back : Screen EXIT