Tool information
Tool number, Edge, Tool offset, Radius,
Magazine
Data set number, TLM Function ON/OFF
Tool load monitoring range set
WCS Geometry Axis
-. Enable, Status : Measurement on/off
-. Measurement/ Status : Measurement
number
-. Select Axis : Measurment Axis
-. Function : Spindle function check
(Refer to Spindle function section)
-. Measured Min/Max : Measured Min/Max
current value
-. Tol.Min/Max : Calculated Min/Max
current value which contain Tolerances. If
detects a certain value of off-range, it
will generate Cycle alarm.
-. Range min/max : Detection range of axis
-. Compensate R : Including the radius of
the tool in the detection range
To Next Page
Loading...
