To Next PageTo Next Page
Need help?Do you have a question about the Siemens REV13 series and is the answer not in the manual?
General| Frequency | 50/60 Hz |
|---|---|
| Category | Controller |
| Number of Channels | 1 |
| Output | Relay, potential-free |
| Input Voltage | 24 V AC/DC |
| Output Voltage | 250 V AC |
| Current Rating | 5 (2) A |
| Storage Temperature | -25…70 °C |
Proper placement for accurate room temperature acquisition, avoiding solar radiation.
Refers to figures B through E for the physical mounting process.
Guidance on verifying electrical connections, emphasizing solid wires.
Local regulations, thermostatic valve settings, and circuit breaker requirements.
Steps to switch on the unit after removing the battery tab.
Guide to selecting the desired language during initial startup.
Introduction to DIP switch functions for various settings.
Setting up sensor calibration using DIP switch 1.
Configuring setpoint limitations using DIP switch 2.
Selecting Celsius or Fahrenheit display using DIP switch 3.
Configuring control actions like PID self-learning, PID 6, PID 12, 2-Point.
Enabling radio clock synchronization using DIP switch 6.
How to reset DIP switch settings using the reset button.
Procedure to enter the expert level for advanced configuration.
Reference for function blocks, codes, and their settings in expert mode.
Verifying display, battery, setpoint response, and actuating device.
Resets temperature and time settings to default values, keeping expert settings.
Resets all user and expert settings to factory defaults.
