28
Building Technologies / HVAC Products CE1B3133x2-en 74 319 0560 0 a 10.10.2006
Info pages boiler / primary controller / main controller
To go to the Info pages:
1. Return to the start page by pressing the ESC button.
2. Press the INFO button.
3. Turn the OK knob until the required page appears.
Boilers 1…6
(1…6: Several boilers only with RMK770)
For each boiler installed, the display shows:
• The actual value of the boiler temperature
This is the current boiler temperature.
• The boiler temperature setpoint
This is the boiler temperature called for by the plant.
• State
On = boiler on
Off = boiler off
• Cause
Here, the reason for the boiler’s state is given (e.g.
protective boiler startup is active).
Primary controller or main controller
(Main controller only with RMH760B)
• Actual value of the flow temperature
This is the current temperature delivered by the heat
exchanger / heat source
• Flow temperature setpoint
This is the temperature called for by the plant
• State:
On = heat generation on
Off = heat generation off
• Cause
Here, the reason for the controller’s state is given (e.g.
the frost protection function is active).
To Next Page
Loading...
